Motor-wheel
from DP Labs, with a cooling system, for a 130/40 P6.5 tire.
Voltage - 60-150V and higher
Speed - 60-160km/h
KV - 24rpm
Power - 3.8kW
Peak power > 30kW
Speed - 60-160km/h
KV - 24rpm
Power - 3.8kW
Peak power > 30kW
Magnets - H48SH operating temperature up to 150 degrees Celsius.
Winding - copper busbar with high-strength, heat-resistant, polyester insulation.
Phase wires - 6AWG
Motor axis - stainless steel.
Rotor with powder coating protecting against rust.
Two sets of Hall sensors and temperature sensors.
Completely sealed motor housing.
Winding - copper busbar with high-strength, heat-resistant, polyester insulation.
Phase wires - 6AWG
Motor axis - stainless steel.
Rotor with powder coating protecting against rust.
Two sets of Hall sensors and temperature sensors.
Completely sealed motor housing.
The cooling system is implemented on the basis of an aluminum sleeve located inside the stator. There are channels for the circulation of coolant inside the aluminum bushing.
The design completely eliminates contact of the coolant with the internal space of the motor, which allows using water as a coolant.
The motor wheel can be installed in a fork with a distance of 220mm.
The design completely eliminates contact of the coolant with the internal space of the motor, which allows using water as a coolant.
The motor wheel can be installed in a fork with a distance of 220mm.
Main characteristics
Additional information:
VOSTOK SCOOTER L.L.C.